Floor Calibration

Hello - I just started using this and find I can’t get the floor to align with my guardian system. If I set the guardian floor to match my physical floor, when I’m in VR sketch and put the controller on the physical floor, it floats about 5" above the VR floor. If I reset the guardian floor and hold it even 2 inches off the physical floor, then when in VR sketch, the virtual floor is a lot higher, light a foot or more and putting my controller on the physical floor makes it go way below the virtual floor. Any idea what could be causing this?

Thank you.

Oops, Never mind. I rebooted my Quest and restarted VR Sketch and everything’s fine.